Figure 10.10: Autoreflact Wizard - Leuze electronic BCL 8 Series Manual

Important parameters
Reflector polling
Reflector polling (autoReflAct) is an operating mode in which no external sensor is required
for triggering. Activation and deactivation of the scanner occur by means of the supplied
reflector which must be mounted in the scanning area of the BCL 8.
For simple alignment in autoReflAct mode, please select the AutoReflAct Wizard.
Once called up, the wizard attempts to establish a connection to the connected BCL 8. If this
is successfully, please select one of the four reflector polling modes under "Mode" from the
menu which then appears. A screen similar to the following appears:

Figure 10.10: AutoReflAct Wizard

Upon activation of the "Search" button, the BCL 8 scans its reading field and attempts to find
a reflector. To do this, the reflector must be positioned in the reading field of the scanner.
After a reflector has been detected, it passes on the start position of the reflector in its
reading field.
By clicking "OK", the values are stored in the scanner and in BCLConfig.
The scanner is now ready for the AutoReflAct operating mode.
Attention!
If other reflective objects are located in the reading window of the scanner besides the re-
flector, the application is to be checked carefully, because these reflective parts could pos-
sibly cause a mistrigger in the scanner!
Notice!
The reflector should be mounted at a distance of max. 300mm from the BCL 8.
52
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
BCL 8 Leuze electronic