Deactivation
Sensor 1 function See menu "switching input"
Immediately after
complete decode
result
Command
character
Time
Scans without info Following a successful read, the scanner waits for this number of
10.4
Host interface tab
Figure 10.5: Host interface tab
Select the desired baud rate, the stop bits, the data bits, the parity and various transmission
modes here. These parameters are not active until following the automatic "Power-On" test
after the BCL 8 is switched on.
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
If this item is activated, the read result is output immediately after the
barcode is decoded.
If the item is deactivated, the read result is sent only after the trigger
signal is returned (=end of reading gate).
The standard online character for the trigger end is the ´-´ character.
This character can be changed only via the tree structure.
If the scanner is activated, the reading gate is automatically closed by
the scanner after this preset time has elapsed (e.g. for test purposes).
scans (sequential scans with no read result) before it automatically
deactivates itself.
BCL 8
Important parameters
47