Operation; Display Elements - Leuze electronic BCL 8 Series Manual

Barcode reader with integrated decoder
Hide thumbs Also See for BCL 8 Series:
Table of Contents

Advertisement

8

Operation

Attention Laser Radiation!
Follow the safety notices in chapter 2.3 on page 6!
Notice!
- Please observe the notices for device arrangement in section 6.2.1.
- If possible, always trigger the laser scanner with the aid of commands, an external signal
transmitter (photoelectric sensor) or the integrated AutoReflAct function. Only then can
you be certain whether a code has been read. If read, the code contents are transmitted;
if not, the NoRead character is transmitted at the end of the reading gate).
- In the event of sporadic readings with longer pauses, the BCL barcode reader can also
be switched to an energy-saving standby mode with the online command "SOS". In stand-
by mode, the motor as well as the laser are switched off. On return to normal operation,
longer boot times will be experienced in this case, however. The online command "SOF"
switches standby mode back off and starts the motor.
8.1

Display elements

On the BCL 8, you will find two LEDs that show the operational readiness and the reading
state of the barcode reader (see table 4.2 on page 11).
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
BCL 8
Operation
39

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bcl 8 s m 0 seriesBcl 8 s m 2 seriesBcl 8 s n 0 seriesBcl 8 s n 2 seriesBcl 8 s m 102Bcl 8 s n 102 ... Show all

Table of Contents