Table of Contents
Advertisement
AT commands
Special commands
The following commands are special commands.
WR (Write)
Writes parameter values to non-volatile memory so that parameter modifications persist through
subsequent resets.
Writing parameters to non-volatile memory does not apply the changes immediately. However, since
the device uses non-volatile memory to determine initial configuration following reset, the written
parameters are applied following a reset.
Note
Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response.
Parameter range
N/A
Default
N/A
RE (Restore Defaults)
Restore device parameters to factory defaults. Does not exit out of Command mode.
Parameter range
N/A
Default
N/A
FR (Software Reset)
Resets the device. The device responds immediately with an OK and performs a reset 100 ms later.
If you issue FR while the device is in Command Mode, the reset effectively exits Command mode.
Parameter range
N/A
Default
N/A
Networking and security commands
The following AT commands are networking and security commands.
C8 (802.15.4 Compatibility)
Sets or displays the operational compatibility with the Legacy 802.15.4 module (S1 hardware).
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
Special commands
67
Advertisement
Table of Contents
