Special Commands; Fr (Software Reset); Re Command; Ac (Apply Changes) - Digi DigiMesh XBee S2C User Manual

AT commands

Special commands

The following commands are special commands.

FR (Software Reset)

Resets the device. The device responds immediately with an OK and performs a reset 100 ms later.
If you issue FR while the device is in Command Mode, the reset effectively exits Command mode.
Parameter range
N/A
Default
N/A

RE command

Restore device parameters to factory defaults.
Parameter range
N/A
Default
N/A

AC (Apply Changes)

Immediately applies new settings without exiting Command mode.
Parameter range
N/A
Default
N/A

WR command

Writes parameter values to non-volatile memory so that parameter modifications persist through
subsequent resets.
Writing parameters to non-volatile memory does not apply the changes immediately. However, since
the device uses non-volatile memory to determine initial configuration following reset, the written
parameters are applied following a reset.
Note Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response.
Parameter range
N/A
Default
N/A
XBee S2C DigiMesh 2.4 User Guide
Special commands
73