Table of Contents
Advertisement
Regulatory information
2.8 Label and compliance information
Host product manufacturers need to follow the sticker guidelines outlined in
requirements.
2.9 Information on test modes and additional testing requirements
Contact a Digi sales representative for information on how to configure test modes for the
XBee/XBee-PRO S2C 802.15.4 RF Module.
2.10 Additional testing, Part 15 Subpart B disclaimer
All final host products must be tested to be compliant to FCC Part 15 Subpart B standards. While the
XBee/XBee-PRO S2C 802.15.4 module was tested to be complaint to FCC unintentional radiator
standards, FCC Part 15 Subpart B compliance testing is still required for the final host product. This
testing is required for all end products, and XBee/XBee-PRO S2C 802.15.4 module Part 15 Subpart B
compliance does not affirm the end product's compliance.
See
FCC notices
for more details.
Europe (CE)
The XBee/XBee-PRO S2C 802.15.4 RF Modules (non-PRO variants) have been tested for use in several
European countries. For a complete list, refer to www.digi.com/resources/certifications.
If XBee/XBee-PRO S2C 802.15.4 RF Modules are incorporated into a product, the manufacturer must
ensure compliance of the final product with articles 3.1a and 3.1b of the Radio Equipment Directive. A
Declaration of Conformity must be issued for each of these standards and kept on file as described in
the Radio Equipment Directive.
Furthermore, the manufacturer must maintain a copy of the XBee/XBee-PRO S2C 802.15.4 RF Module
user guide documentation and ensure the final product does not exceed the specified power ratings,
antenna specifications, and/or installation requirements as specified in the user guide.
Maximum power and frequency specifications
For the through-hole device:
Maximum power: 9.82 mW (9.92 dBm) Equivalent Isotropically Radiated Power (EIRP) at normal
n
condition.
Frequencies: 5 MHz channel spacing, beginning at 2405 MHz and ending at 2480 MHz.
n
For the surface-mount device:
Maximum power: 12.65 mW (11.02 dBm) EIRP.
n
Frequencies: 5 MHz channel spacing, beginning at 2405 MHz and ending at 2480 MHz.
n
OEM labeling requirements
The "CE" marking must be affixed to a visible location on the OEM product. The following figure shows
CE labeling requirements.
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
Europe (CE)
OEM labeling
157
Advertisement
Table of Contents
