Table of Contents
Advertisement
AT commands
Default
SB (Stop Bits)
Parameter range
0 - 1
Parameter
0
1
Default
0
Special commands
The following commands are special commands.
AC (Apply Changes)
Immediately applies new settings without exiting Command mode.
Parameter range
N/A
Default
N/A
CN (Exit Command Mode)
Immediately exits Command Mode and applies pending changes.
Parameter range
N/A
Default
N/A
FR (Software Reset)
Resets the device. The device responds immediately with an OK and performs a reset 100 ms later.
If you issue FR while the device is in Command Mode, the reset effectively exits Command mode.
Parameter range
N/A
Default
N/A
XBee®/XBee-PRO XTend Compatible (XTC) DigiMesh RF Module User Guide
Configuration
One stop bit
Two stop bits
Special commands
56
Advertisement
Table of Contents
