Special Commands; Ac (Apply Changes); Fr (Software Reset); Re Command - Digi XBee SX 868 User Manual

AT commands

Special commands

The following commands are special commands.

AC (Apply Changes)

Immediately applies new settings without exiting Command mode.
Immediately applies new settings without exiting Command Mode.
Parameter range
N/A
Default
N/A

FR (Software Reset)

Resets the device. The device responds immediately with an OK and performs a reset 100 ms later.
If you issue FR while the device is in Command Mode, the reset effectively exits Command mode.
Parameter range
N/A
Default
N/A

RE command

Restore device parameters to factory defaults.
Parameter range
N/A
Default
N/A

WR command

Writes parameter values to non-volatile memory so that parameter modifications persist through
subsequent resets.
Note Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response.
Parameter range
N/A
Default
N/A
XBee® SX 868 RF Module User Guide
Special commands
91