Dl (Destination Address Low); My (Source Address); Sh (Serial Number High); Serial Number Low) - Digi XBee S2C 802.15.4 User Manual

AT commands
Default
0

DL (Destination Address Low)

Set or display the lower 32 bits of the 64-bit destination address. When you combine DH with DL, it
defines the destination address that the device uses for transmissions in Transparent mode.
The destination address is also used for I/O sampling in both Transparent and API modes.
0x000000000000FFFF is the broadcast address. It is also used as the polling address when the device
functions as end device.
Parameter range
0 - 0xFFFFFFFF
Default
0

MY (Source Address)

Sets or displays the device's 16-bit source address. Set MY = 0xFFFF to disable reception of packets
with 16-bit addresses. Regardless of MY, messages addressed to the 64-bit long address of the device
are always delivered.
Parameter range
0 - 0xFFFF
Default
0

SH (Serial Number High)

Displays the upper 32 bits of the unique IEEE 64-bit extended address assigned to the product family
in the factory.
The 64-bit source address is always enabled. This value is read-only and it never changes.
Parameter range
0 - 0xFFFFFFFF [read-only]
Default
Set in the factory
SL (Serial Number Low)
Displays the lower 32 bits of the unique IEEE 64-bit RF extended address assigned to the product
family in the factory.
The device's serial number is set at the factory and is read-only.
Parameter range
0 - 0xFFFFFFFF [read-only]
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
Networking and security commands
70