Table of Contents
Advertisement
AT commands
BD (Interface Data Rate)
To request non-standard baud rates with values between 1200 b/s and 250,000 b/s (0x4B0 and
0x3D090), you can use the Serial Console toolbar in XCTU to configure the serial connection (if the
console is connected), or click the Connect button (if the console is not yet connected).
When you send non-standard baud rates to a device, it stores the closest interface data rate
represented by the number in the BD register. Read the BD command by sending ATBD without a
parameter value, and the device returns the value stored in the BD register.
The RF data rate is not affected by the BD parameter.
Non-standard interface data rates
The firmware interprets any value from 0x4B0 through 0x3D090 as an actual baud rate. When the
firmware cannot configure the exact rate specified, it configures the closest approximation to that
rate. For example, to set a rate of 57600 b/s send the following command line: ATBDE100. Then, to
find out the closest approximation, send ATBD to the console window. It sends back a response of
0xE0D1, which is the closest approximation to 57600 b/s attainable by the hardware.
Note
When using XCTU, you can only set and read non-standard interface data rates using the XCTU
Terminal tab. You cannot access non-standard rates through the Modem Configuration tab.
When you send the BD command with a non-standard interface data rate, the UART adjusts to
accommodate the interface rate you request. In most cases, the clock resolution causes the stored
BD parameter to vary from the sent parameter. Sending ATBD without an associated parameter value
returns the value actually stored in the device's BD register.
The following table provides the parameters sent versus the parameters stored.
BD parameter sent (HEX)
0
4
7
E100
1C200
Parameter range
Standard baud rates: 0x0 - 0x8
Parameter
0x0
0x1
0x2
0x3
0x4
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
Interface data rate (b/s)
1200
19,200
115,200
57,600
115,200
Description
1200 b/s
2400 b/s
4800 b/s
9600 b/s
19200 b/s
Serial interfacing commands
BD parameter stored (HEX)
0
4
7
E0D1
1C2B8
86
Advertisement
Table of Contents
