Special Commands; Wr (Write); Re (Restore Defaults); Fr (Software Reset) - Digi XBee User Manual

AT commands

Special commands

The following commands are special commands.

WR (Write)

Writes parameter values to non-volatile memory so that parameter modifications persist through
subsequent resets.
If you make changes without writing them to non-volatile memory, the device reverts back to
previously saved parameters the next time the device is powered-on.
Note Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response.
Parameter range
N/A
Default
N/A

RE (Restore Defaults)

Restore device parameters to factory defaults.
The RE command does not write restored values to non-volatile (persistent) memory. Issue the WR
(Write) command after issuing the RE command to save restored parameter values to non-volatile
memory.
Parameter range
N/A
Default
N/A

FR (Software Reset)

If you issue FR while the device is in Command Mode, the reset effectively exits Command mode.
Forces a software reset on the device. The reset simulates powering off and then on again the device.
The device responds immediately with an OK and performs a reset 100 ms later.
Parameter range
N/A
Default
N/A
Note Minimum firmware version required: 1.x80. Firmware versions are numbered in hexadecimal
notation.
XBee/XBee-PRO S1 802.15.4 (Legacy) User Guide

Special commands

47