Digi XBee S2C 802.15.4 User Manual page 120

Operate in API mode
Offset Size
15 8-bit
16 16-bit
18-n variable Parameter
EOF 8-bit
Examples
Each example is written without escapes—AP = 1—and all bytes are represented in hex format. For
brevity, the start delimiter, length, and checksum fields have been excluded.
Set remote command parameter
Set the NI string of a device with the 64-bit address of 0013A20012345678 to "Remote" and apply the
change immediately.
The corresponding Remote AT Command Response- 0x97
success.
7E 00 15 17 27 00 13 A2 00 12 34 56 78 FF FE 02 4E 49 52 65 6D 6F 74 65 F6
Frame
type Frame ID
0x17 0x27
Request Matches
response
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
Frame Field Description
Bit field of options that apply to the remote AT command request:
Remote
command
Bit 0: Disable ACK [0x01]
n
options
Bit 1: Apply changes on remote [0x02]
n
l
Bit 2: Reserved (set to 0)
n
Bit 3: Reserved (set to 0)
n
Bit 4: Send the remote command securely [0x10]
n
l
Note Option values may be combined. Set all unused bits to 0.
AT The two ASCII characters that identify the AT Command.
command
If present, indicates the requested parameter value to set the
given register.
value
If no characters are present, it queries the current parameter
(optional)
value and returns the result in the response.
Checksum 0xFF minus the 8-bit sum of bytes from offset 3 to this byte
(between length and checksum).
16-bit
64-bit dest dest
0x0013A200 0xFFFE
12345678
Unknown Apply Change
If not set, changes will not applied until the device
receives an AC command or a subsequent command
change is received with this bit set
Requires a secure session be established with the
destination
with a matching Frame ID will indicate
Command AT
options command
0x02 0x4E49
"NI"
Frame descriptions
Parameter
value
0x52656D6F7465
"Remote"
120