Table of Contents
Advertisement
Commissioning
7.2.1.1
Align transmitter
One of the adjustment templates supplied can be used to align the transmitter.
The adjustment templates differ in the way the cutouts are arranged. It does not matter
which adjustment template you select for the transmitter.
Alternatively you can use an adjustment template that is screwed to a bracket. Installation
is described at the end of this chapter.
Attach an adjustment template with magnets to the upper tool. The tip of the upper tool
}
must sit in the notch on the stop of the adjustment template.
Align the alignment grid of the adjustment template to the contour of the upper tool.
Fig.: Attach the adjustment template to the transmitter
The illuminated target area must completely envelop the receiver. If you hold a white
}
sheet of paper behind the receiver you will be able to see the contours of the receiver
better.
Operating Manual PSENvip R, PSENvip R LR,PSENvip E
1003449-EN-06
Magnet
Alignment grid
Magnet
Back gauge with notch
Cross-hair
Align the
alignment grid
on the upper
tool
Centre point of
the upper tool
in the notch on
the back stop
| 85
Advertisement
Table of Contents
