Acknowledgement After Protected Field Meets The Workpiece - Pilz PSENvip R Operating Manual

Function description
4.8.2.2

Acknowledgement after protected field meets the workpiece

The press stroke is stopped when the protected field meets the workpiece. The reduced
protected field starts after the downward movement is stopped with the acknowledgement
(e.g. acknowledgement button). The following states are available:
Press is at top dead centre
}
Protected field: Free
Signal/action
Foot switch
Acknowledgement of "re-
duced protected field" pro-
tected field mode
System-Init
OSSD
Creep speed
Downward movement (rapid traverse)
}
Full protected field active
Protected field: Free
Signal/action
Foot switch
Acknowledgement of "re-
duced protected field" pro-
tected field mode
System-Init
OSSD
Creep speed
Downward movement is stopped, full protected field meets the workpiece
}
Protected field: Interrupted
Operating Manual PSENvip R, PSENvip R LR,PSENvip E
1003449-EN-06
Status Press
0
0
1
1
0
Status Press
1
0
0
v > 10 mm/s
1
0
v = 0
| 45