Table of Contents
Advertisement
Commissioning
7.2.1.3
Align receiver
Attach an adjustment template with magnets to the upper tool. The tip of the upper tool
}
must sit in the notch on the stop of the adjustment template.
Align the alignment grid of the adjustment template to the contour of the upper tool.
}
Open the Adjustment menu in the web interface. You will see the tool displayed with the
bending lines and a template. The example below shows a tool on which the bending line is
approximately 7 mm to the left of centre.
Fig.: Incorrect adjustment
The receiver is correctly aligned with the transmitter when
The cross-hairs of both adjustment templates overlap
}
The quadrants form a full circle and
}
The centre point of the upper tool is on the bending line.
}
Operating Manual PSENvip R, PSENvip R LR,PSENvip E
1003449-EN-06
Align the
alignment grid
on the upper
tool
Centre point of
the upper tool
in the notch on
the back stop
| 89
Advertisement
Table of Contents
