Pilz PSENvip R Operating Manual page 90

Commissioning
The correct adjustment image is shown in the following diagram.
Fig.: Correct adjustment image
Adjust the direction of the receiver as described in the section entitled "Adjustment direc-
}
tions of transmitter and receiver", until a correct adjustment image is displayed.
Remove the adjustment templates.
}
The correct adjustment image must correspond to the image shown in the following dia-
gram:
The bending line should be on the vertical guide.
}
The tool centre point should be aligned with the horizontal guide (the horizontal guide is
}
firmly in the middle of the range bar (see
Fig.: Correct adjustment image
Press the button Show guide frame.
}
Operating Manual PSENvip R, PSENvip R LR,PSENvip E
1003449-EN-06
INFORMATION
The adjustment templates have different cut-outs around the cross-hair.
This makes it easier to evaluate the adjustment direction required by the
transmitter and receiver.
Make adjustment during tool change [ 92]).
| 90