Align Transmitter And Receiver - Pilz PSENvip R Operating Manual

Commissioning
7.2.1

Align transmitter and receiver

Once installed, the transmitter and receiver must be exactly aligned to each other and to
the centre point of the upper tool. The vertical and horizontal alignment is performed using
adjustment templates and is displayed on the web interface.
The PSENvip transmitter and receiver can be adjusted in three directions.
Direction
A
B
C
Guidelines for the mechanical alignment of transmitter and receiver:
When making the alignment, the nuts on the bolt connecting the PSENvip to the adjust-
}
ment plate should only be hand-tightened.
There are three notches on the adjustment plate and auxiliary adjustment plate for rotat-
}
ing the transmitter and receiver. The transmitter or receiver is inserted into the slot holes
on the adjustment plate (adjustment direction B).
Operating Manual PSENvip R, PSENvip R LR,PSENvip E
1003449-EN-06
C
C
What?
Move horizontally within the groove of the adjustment plate
Rotate on a horizontal plane within the slot holes of the adjustment
plate
Move vertically by adjusting the nuts on the bolts
A
B
| 83