Install Transmitter And Receiver - Pilz PSENvip R Operating Manual

Installation
5.2

Install transmitter and receiver

The fastening kit consists of an adapter plate, adjustment plate with slot nut and a mounting
plate. The bracket on the upper die must have a corresponding groove in which to insert
the slot nut (see diagram).
Fig.: Dimensions of adapter plate with groove (dimensions in mm)
The process for installing the transmitter and receiver is the same.
To install the system, proceed as follows:
Fasten the adjustment plate and mounting plate as shown in the following diagram. En-
}
sure that the flat washers, spring washers and nuts are attached in the right order.
Operating Manual PSENvip R, PSENvip R LR,PSENvip E
1003449-EN-06
14 +0,3
B
7 +0,3
1
17 +0,5
(4x) ø15
A-A
(4x) ø8.4
B
(71.5)
35
27
| 72