Usb Cable Clamp Attachment/Removal - Pro-face PS-3600G Series User Manual

3.3.2

USB Cable Clamp Attachment/Removal

This clamp is used to prevent the USB cable connected to the USB Host Interface on the bottom of the PS-G
unit from being unplugged due to vibration or other causes.
Attachment
As shown below, insert the USB Cable Clamp's band through the Bridge. Pass the USB cables through the
Cable Clamp's band and securely tighten the clamp band around the cables.
• Be sure the clamp is securely holding the USB cable's plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp pointing upwards - not to the
side. This is to keep the clamp from interfering with nearby connectors and their cables.
Removal
To remove the clamp from the USB cables, push down on the clamp strap's clip to release it while pulling up
on the clamp.
Band
Cable Collars
USB Cable
Clamp
Chapter 3 Hardware Installation
Clamp
Bridge
Clip
3-15