Usb Cable Clamp For Usb (Type A) - Pro-face GP4104G1D Hardware Manual

Installation and Wiring

USB Cable Clamp for USB (Type A)

Introduction
Attaching the USB Cable Clamp
158
When using a USB device, attaching a USB cable clamp to the USB interface to
prevent the USB cable from being disconnected.
RISK OF EXPLOSION IN HAZARDOUS LOCATIONS
Confirm that the USB cable has been attached with the USB cable clamp before
using the USB interface.
Remove power before attaching or detaching any connectors to or from the unit.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
NOTE: Watch your fingers. The edge of the clip is sharp.
Step Action
1
Mount the clip to the USB mark
clip matches the 27 to 43.5 mm [1.06 to 1.71 in.] length of the USB connector.
2 Align the clip and the USB cable connector shell. Adjust the position of the
holes where the clip is attached. To ensure stability, select the clip-hole
position that is closest to the base of the connector shell.
Pass the tie through here.
WARNING
connector shell so that it overlaps. The
27 to 43.5 mm
[1.06 to 1.71 in.]