Table of Contents
Advertisement
• The gasket must be inserted correctly into the groove for the PS-G's moisture
resistance to be equivalent to IP65f.
• Since the gasket is flexible but not elastic, be careful not to stretch it unecessarily,
as doing so could tear the gasket.
• Be sure the gasket's seam is not inserted into any of the unit's corners, only in the
straight sections of the groove. Inserting it into a corner may lead to its eventually
tearing.
• To ensure stable resistance against dust and moisture, insert the gasket so that the
seam is at the bottom of the PS-G unit.
• The upper surface of the gasket should protrude approximately 2 mm [0.08 in.] out
from the groove. Be sure to check that the gasket is correctly inserted before
installing the PS-G into a panel.
Chapter 7 Maintenance
Unit:mm [in.]
2.0 [0.08]
7-5
Advertisement
Table of Contents
