Mounting A Vesa Arm - Pro-face PS-3600G Series User Manual

PS-3600G Series User Manual
(4) Use a Phillips screwdriver to tighten each
fastener screw and secure the PS-G in
place.
3.1.2

Mounting a VESA Arm

The PS-G unit can be mounted on a stand or wall by attaching a commercially available arm or wall-mounting
adapter to the arm mounting hole (VESA-75 mm [2.95 in.] specification) on the rear face of the PS-G unit.
Secure the arm or adapter with M4 screws (maximum length: 6 mm [0.24 in.]). The tightening torque is 0.7 to
•
0.8 N m. For the attaching procedure, refer to the instruction manual provided with the arm or wall-mounting
adapter.
• If the VESA arm is installed with the PCMCIA card adapter unit (PSG-PCM00) attached to the
PS-G unit, the inclination of the display face might be limited depends on the form of the VESA
arm.
3-6
• Tightening the screws with too much force can damage the PS-G unit's plastic case.
• The torque required to tighten these screws is 0.5 N
•
m.