Pro-face PS-3600G Series User Manual page 107

PS-3600G Series User Manual
(5) Remove the setscrew (1) from the Backlight Unit.
(6) Lift the edge of the Backlight Unit, and remove the unit while sliding it along the groove.
(7) Insert a new Backlight Unit while sliding it along the groove.
(8) Secure both backlights in place using the backlight screw. The necessary torque is 0.147N•m.
(9) Insert the Backlight Unit cable to the connector on the inverter board, and the secure the cable with the
cable clamp.
7-8
• Be careful that no dust or dirt adheres to the backlight surface or to the backligh
holder.
• Be careful not to soil the Backlight with moisture, oil content or finger prints;
otherwise, the life duration of the Backlight will be shortened.
• Be sure the cable is inserted completely into the backlight connector. Failure to do
so may cause arcing, which can damage the connector.
Setscrew
Backlight Unit
Backlight Unit