Wiring Precautions; Connecting The Power Cord - Pro-face PS-3600G Series User Manual

3.2 Wiring Precautions

This section describes the procedures and precautions for wiring power cords.
3.2.1

Connecting the Power Cord

To avoid an electric shock, prior to connecting the PS-G unit's power cord terminals to the
power terminal block, confirm that the PS-G unit's power supply is completely turned OFF,
via a breaker, or similar unit.
The PS3600G-T41 units are designed to use AC100 to 240V input. The PS3600G-T41-
24V is designed to use only DC24V. Supplying a power voltage other than that specified
will damage the power source and the PS-G unit.
When the FG terminal is connected, be sure the wire is grounded.
When wiring the PS3600G-T41 unit (AC100 to 240V)
Double-insulated Wire
Power Cord 1.25 to 2.0mm
(16 to 14 AWG)
V2-MS3 compatible
(J.S.T. Mfg. Co., Ltd)
Recommended
*1
Ring Terminal
*1 In order to prevent a short circuit caused by loose screws, make sure to use a crimp-type terminal with insulating
sleeve.
• When the FG terminal is connected, be sure the wire is grounded. Not grounding
the PS-G unit will result in excess noise and vibration.
• The SG and FG terminals are connected internally in the PS-G unit.
• When connecting the SG wire to another device, be sure that the design of the
system/connection does not produce a shorting loop.
AC Power Cord
2
[0.0024 to 0.0062inch
3.2mm [0.13 in.]
or more
less than
6mm [0.24 in.]
Chapter 3 Hardware Installation
Grounding Wire
2
1.25 to 2.0mm [0.0024 to 0.0062inch
2
]
(16 to 14 AWG)
V2-P4 compatible
(J.S.T. Mfg. Co., Ltd)
less than
7mm [0.28 in.]
2
]
4.3mm [0.17 in.]
or more
3-7