Table of Contents
Advertisement
Installation
Be sure all cable connectors are securely attached to the PS-G unit. A loose connection may cause
incorrect input or output signals.
Wiring
Be sure to ground the PS-G unit's FG wire separately from other equipment FG lines. Also, be sure to use
a grounding resistance of 100Ω or less and a 2mm
cable standard. Otherwise, electric shock or malfunctions may result.
Be sure to use only the designated torque to tighten the PS-G unit's terminal block screws. If these screws
are not tightened firmly, it may cause a short-circuit, fire or incorrect unit operation.
Be sure that metal particles and wiring debris do not fall inside the PS-G unit. They can cause a fire,
malfunction or incorrect unit operation.
Maintenance
Do not reset or turn the PS-G OFF, or insert or remove the CF Card while the PS-G unit's CF Card is being
accessed. Otherwise, CF Card internal data may be damaged or lost.
Unit Disposal
When the product is disposed of, it should be done so according to your country's regulations for similar
types of industrial waste.
General Safety Precautions
Do not press on the PS-G unit's display with excessive force or with a hard object, since it can damage the
display. Also, do not press on the touch panel with a pointed object, such as the tip of a mechanical pencil
or a screwdriver, since doing so can damage the touch panel.
Do not install the PS-G where the ambient temperature exceeds the specified range. Doing so may cause
a unit malfunction.
To prevent abnormally high temperatures from occurring inside the PS-G, do not restrict or block the PS-G
unit's rear-face ventilation slots.
Do not operate the PS-G in areas where large, sudden temperature changes can occur. These changes
can cause condensation to form inside the PS-G, possibly causing it to malfunction.
Do not allow water, liquids or metal fragments to enter inside the PS-G unit's case, since they can cause
either a malfunction or an electric shock. The allowable pollution degree is 2.
Do not operate or store the PS-G in locations where it can be exposed to direct sunlight, high
temperatures, excessive dust, moisture or vibration.
4
2
2
[0.0062inch
] or thicker wire, or your country's appli-
Advertisement
Table of Contents
