Pro-face PS-3600G Series User Manual page 36

Creating a Panel Cut
Create the correct sized opening required to install the PS-G, using the installation dimensions given.
The installation gasket and the installation fasteners are required when installing the PS-G.
SEE 2.4.2 Panel Cut Dimensions (page2-10)
• Check that the installation panel or cabinet's surface is flat, in good condition and has no jagged
edges. Also, if desired, metal reinforcing strips can be attached to the inside of the panel, near
the Panel Cut, to increase the panel's strength.
• Panel thickness should be from 1.6mm [0.06 in.] to 5.0mm [0.2 in.]. Decide the
panel's thickness based on the level of panel strength required.
• For easier maintenance, operation, and improved ventilation, be sure to install
the PS-G at least 100 mm [3.94 in.] away from adjacent structures and other
equipment.
Panel
Panel Cut
Area
100
[3.94]
100
[3.94]
100
[3.94]
Chapter 3 Hardware Installation
1.6mm [0.06 in.] to 10.0mm [0.39 in.]
100
[3.94]
100
[3.94]
100
[3.94]
Unit: mm [in.]
100
[3.94]
3-3