Chapter 3 Installation And Wiring; Installation; Installation Procedures - Pro-face GP-2400 Series User Manual

Chapter
3
3.1

Installation

3.1.1 Installation Procedures

Follow the steps given below when installing the GP.
Check the Installation Gasket's Seating
It is strongly recommended that you use the installation gasket, since it absorbs
vibration in addition to repelling water.
Place the GP on a level surface with the display panel facing downward. Check
that the GP's installation gasket is seated securely into the gasket's groove, which
runs around the perimeter of the panel's frame.
For details about installing the gasket, refer to
• Before installing the GP into a cabinet or panel, check that the Instal-
lation gasket is securely attached to the unit.
• A gasket which has been used for a long period of time may have
scratches or dirt on it, and could have lost much of its dust and drip
resistance. Be sure to change the gasket periodically, or when
scratches or dirt become visible.
• The conforming installation gasket types are PS400-WP00-MS (for
GP-2400 Series) and GP570-WP10-MS (for GP-2500/2600 Series).
• Do not insert the joint of the installation gasket in the corner of the
GP. If you do it, the joint will be pulled so that it may cause the
installation gasket to be torn.
GP-2400/2500/2600 Series User Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1. Installation
2. Wiring Cautions
3. Tool Connector
Installation and Wiring
6.1.2 Installation Gasket Check/Replacement
Rear
face
4. Ethernet Cable Connector
5. CF Card Installation and Removal
6. Sound Output
Installation
Gasket
3-1