Power Connection; Projector Components - Christie Crimson Series Service Manual

Power connection

The projector uses an innovative dual AC inlet power system that offers two power modes.
To operate at full brightness, power the projector using AC Input 1 if the appropriate high power
source is available. To operate in limited power mode, power the projector using standard lower power
sources using AC Input 2. A different power cord is provided for each power source. A 20 A rated wall
breaker is required at the installation when using Input 1. A 15 A rated wall breaker is required at the
installation when using Input 2.

Projector components

Identify the main components of the projector.
ID Component
A Projection lens
B Front IR
C Mounting and rigging holes.
D Communication and input
panel
E Service compartment
F Tool box
G Christie TAP
H Keypad interface
Crimson Service Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102733-02 Rev. 1 (01-2020)
Copyright 2020 Christie Digital Systems USA, Inc. All rights reserved.
©
Description
A variety of lenses can be used with the projector. Available lenses are
listed in the Crimson and Mirage Specifications Guide (P/N:
020-102724-XX).
Receives transmissions from the IR remote.
M12 x 1.75 holes for projector feet installation and offer mounting and
rigging points. Four holes located on the top, and four located on the
bottom.
Connects media sources to either the ports on the option cards or the
IMXB.
Access to fold mirror, optical zoom/focus, and DMD convergence
adjustments.
Provides tools for Christie qualified technicians.
Enables Android devices to communicate with the projector using near
field communication.
Controls the projector.
Introduction
7