Crimson 31:
4. Pull up the board off of the pin.
5. Replace the board, if required.
6. To re-install, repeat these steps in reverse order.
Replacing the status LED board (SLB)
The status LED board (SLB) provides a visual about the operational state of the projector.
1. Remove the rear cover (on page 42).
2. Disconnect the harness (J1(SLB).
3. Remove the two screws securing the board.
Two metal washers are behind the SLB. Ensure they do not fall into the projector when the
screws are removed. They should be replaced behind the new SLB upon re-install. Newer units
may not have these washers.
Crimson/Mirage 25:
Crimson Service Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102733-02 Rev. 1 (01-2020)
Copyright
2020 Christie Digital Systems USA, Inc. All rights reserved.
©
Printed circuit boards and sensors
94