Aligning The Boresight - Christie Crimson Series Service Manual

3. Select LENS OFFSET.
4. Use the arrows to adjust the offset to display a square image on the screen, with minimal
projector aiming error.
5. To exit to the home page, select Back.

Aligning the boresight

The boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector
tilt.
1. Display the boresight test pattern.
a) On the remote keypad, press Test.
On the built-in keypad, press the soft key that displays Test on the display panel
b) To cycle to Boresight, press the Up Arrow key.
c) Press Enter.
2. Focus the image on cross-hair image I.
3. Evaluate the focus on cross-hair image II and III.
• If all three images are in focus, no further action is required.
• If boresight is required, continue to step 4.
The adjustment screws (A) on the lens mount affects the corresponding cross-hairs on the test
pattern.
Crimson Service Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102733-02 Rev. 1 (01-2020)
Copyright 2020 Christie Digital Systems USA, Inc. All rights reserved.
©
Service setups
19