Installing The Cisco 7609 Chassis In The Rack - Cisco 7609 Installing

Installing the Cisco 7609 Chassis in the Rack

Installing the Cisco 7609 Chassis in the Rack
Note
Caution
Tip
Warning
Step 1
Step 2
Step 3
Step 4
Cisco 7609 Internet Router Installation Guide
3-8
If you are not installing the Cisco 7609 Internet Router in the rack, you must
install the stabilizer kit. See
page 3-10.
Mount the chassis in the rack before installing the power supplies or line cards.
You are now ready to install the Cisco 7609 chassis in the rack.
We recommend that you have a third person to assist in this procedure.
Two people are required to lift the empty chassis. Grasp the chassis
underneath the lower edge and lift with both hands. To prevent injury, keep
your back straight and lift with your legs, not your back.
To install the Cisco 7609 chassis in the equipment rack, perform these steps:
With a person standing at each side of the chassis, grasp the chassis handle with
one hand and use the other hand near the back of the chassis for balance. Slowly
lift the chassis in unison. Avoid sudden twists or moves to prevent injury.
Position the chassis in the rack as follows. (See
If the front of the chassis (front panel) is at the front of the rack, insert the
a.
rear of the chassis between the mounting posts.
If the rear of the chassis is at the front of the rack, insert the front of the
b.
chassis between the mounting posts.
Rest the chassis on the shelf brackets and crossbar bracket.
Align the mounting holes in the L bracket with the mounting holes in the
equipment rack.
Chapter 3 Installing the Cisco 7609 Internet Router
"Installing the Stabilizer Kit" section on
Figure 3-4.)
OL-5079-04