Removing The Server And Adjustable Guide Rails - Huawei TaiShan 200 2280 Maintenance And Service Manual

TaiShan 200 Server
Maintenance and Service Guide (Model 2280)
Step 6 Remove the other guide rail in the same way.
----End

5.4.4.2 Removing the Server and Adjustable Guide Rails

Step 1 Wear an ESD wrist strap. For details, see
Step 2 Power off the server. For details, see
Step 3 Disconnect all power cables and signal cables from the server.
Step 4 Remove the server.
1.
2.
3.
Step 5 Loosen the M6 screw from the lowest square hole at the rear of a guide rail. See
(1) in
Step 6 Remove the two plugs from the middle square holes on both ends. See (2) in
Figure
Step 7 Slightly lift the guide rail, retract it from the square holes, and take it out. See (3)
and (4) in
Issue 04 (2020-01-16)
Loosen the captive screws on the server panel using a screwdriver. See (1) in
Figure 5-11.
Figure 5-11 Removing the server
Pull out the server along the guide rails away from the cabinet. See (2) in
Figure 5-11.
Place the removed server on an ESD platform.
Figure 5-12.
5-12.
Figure 5-12.
Copyright © Huawei Technologies Co., Ltd.
5.2 ESD Protection.
5.4.2 Powering Off the
5 Removal and Installation
Server.
84