Table of Contents
Advertisement
TaiShan 200 Server
Maintenance and Service Guide (Model 2280)
Port
Serial port
GE electrical
port
25GE optical
port
PSU socket
2.4 Rear Panel Indicators
Figure 2-11
Issue 04 (2020-01-16)
Type
RJ45
RJ45
SFP28
-
shows the indicators on the rear panel of the server.
Copyright © Huawei Technologies Co., Ltd.
Quanti
Description
ty
1
The serial port is used as the system
serial port by default. You can set it as
the iBMC serial port by using the
iBMC command. This port is used for
debugging.
NOTE
For details about how to set the system
serial port as the iBMC serial, see Logging
In over the Serial Port in
to the iBMC
4/8
● Each FlexIO card provides four GE
electrical ports. A maximum of
eight GE electrical ports can be
provided through the two FlexIO
cards.
● This 1000 Mbps Ethernet port is
used for FlexIO card, and supports
10/100/1000 Mbps auto-
negotiation.
4
A FlexIO card can provide a maximum
of four 25GE optical ports.
NOTE
The 25GE optical ports support rate
adaptation to 10GE, and optical modules
of different rates are required.
1/2
Determine the number of PSUs based
on actual requirements, but ensure
that the rated power of the PSUs is
greater than that of the server. You
are advised to configure two PSUs to
ensure reliable device operating.
When one PSU is used, Predicted PSU
Status cannot be set to Active/
Standby on the iBMC WebUI.
2 Components
8.3 Logging In
CLI.
12
Advertisement
Table of Contents
