Table of Contents
Advertisement
TaiShan 200 Server
Maintenance and Service Guide (Model 2280)
Configuration
● [1]: The front drives in a server with 25 x 2.5-inch drives in Expander mode or
● [2]: I/O module 3 supports only 2.5-inch drives, and I/O modules 1 and 2
● [3]: CPU SAS pass-through requires a SAS riser card. By default, it is installed
● [4]: The NVMe SSDs in slots 8 to 19 of a server with 8 x 2.5-inch SAS/SATA
● [5]: Servers with Kunpeng 920 5220 or 3210 processors do not support the
2.6.2 SAS/SATA Drive Indicators
Figure 2-19
Figure 2-19 SAS/SATA drive indicators
Table 2-10 Description of SAS/SATA drive indicators
Drive Activity
Indicator (Green
Indicator)
Steady on
Blinking at 4 Hz
Steady on
Blinking at 1 Hz
Off
Steady on
Issue 04 (2020-01-16)
Maximum
Front Drives
a server with 8 x 2.5-inch SAS/SATA drives + 12 x 2.5-inch NVMe SSDs can
only be 2.5-inch drives, and the front drives in a server with 12 x 3.5-inch
drives in Expander mode or a server with 12 x 3.5-inch drives in pass-through
mode can only be 3.5-inch drives.
support 2.5-inch and 3.5-inch drives.
on I/O module 2.
drives + 12 x 2.5-inch NVMe SSDs support only PCIe 3.0.
configuration of 24 x 2.5-inch SAS/SATA pass-through drives.
shows the SAS/SATA drive indicators.
Drive Fault
Indicator (Yellow
Indicator)
Off
Off
Blinking at 1 Hz
Blinking at 1 Hz
Steady on
Steady on
Copyright © Huawei Technologies Co., Ltd.
Maximum Rear Drives
Description
The drive is in position.
Data is being read or written normally,
or data on the primary drive is being
rebuilt.
The drive is being located by the RAID
controller card.
The data on the secondary drive is
being rebuilt.
A member drive in the RAID array is
removed.
A member drive in the RAID array is
faulty.
2 Components
Drive
Manageme
nt Mode
19
Advertisement
Table of Contents
