Table of Contents
Advertisement
TaiShan 200 Server
Maintenance and Service Guide (Model 2280)
Removing a Drive
Before removing a hard drive, you can use Smart Provisioning to delete data from
the hard drive. For details, see "Erasing Hard Disks" in the
User Guide (aarch64)
Step 1 Wear an ESD wrist strap. For details, see
Step 2 If the server is equipped with a front bezel, remove the bezel before removing a
front drive. For details, see
Step 3 Press the ejector release button on the drive. See (1) in
The ejector lever automatically ejects.
Figure 5-17 Removing a drive
Step 4 Holding the ejector lever, pull out the drive for about 3 cm (1.18 in.) and wait for
the drive to stop working. See (2) in
drive is offline, wait for at least 30 seconds until it stops rotating, and then remove
the drive from the server. For NVMe SSDs, remove the drive from the server after
the drive is offline. See (3) in
Issue 04 (2020-01-16)
NO TICE
.
● You do not need to power off the server when removing a drive.
● Before replacing a drive, confirm the slot where the drive to be replaced is installed and
mark the slot for the drive so that the drive can be quickly recovered when it is used
again.
Copyright © Huawei Technologies Co., Ltd.
5.2 ESD
5.5 (Optional) Front
Figure
5-17. For SAS/SATA drives, after the
Figure
5-17.
5 Removal and Installation
Smart Provisioning
Protection.
Bezel.
Figure
5-17.
89
Advertisement
Table of Contents
