Additional Switches Required; Connecting A Profiler Switch; Single And Dual Switches Of Other Brands - Kemper PROFILER Main Manual

Expression Pedals and Foot Switches 96
✓
A tutorial video demonstrating setting up of expression pedals can be found at: www.kemper-amps.com/video

Additional Switches Required?

Switches can be connected to both the PROFILER and the PROFILER Remote. Switching functions can be
assigned globally. These functions include Rig up/down, activating/deactivating stomps and effects, engaging the
Tuner Mode, tapping the tempo, or triggering Beat Scanner temporarily.
The PROFILER Remote has several built-in switches: Each of the four Effect Buttons can assume multiple switching
functions that can be assigned and stored by Rig. In addition, the LOOPER, TAP, and TUNER buttons can be
reassigned to other switching functions, globally. If you still feel the need for even more switches, you could connect
single or dual switches to each of the four PEDAL inputs.

Connecting a PROFILER Switch

Connect the KEMPER PROFILER Switch using a TRS cable to one of the PEDAL inputs and select the "PROFILER
Switch" mode on the corresponding "Pedal
1-6" page in System Settings. Assign your preferred switching functions
to the A and B switches. Then hold "Calibrate" and trigger each switch once. Release "Calibrate". Done!

Single and Dual Switches of Other Brands

The PROFILER requires so-called "momentary" switches. Channel switches for tube amplifiers are not compatible
with the PROFILER, as they use a latching mechanism that would only trigger their assigned switching function
every other hit. Single switches are connected via a TS cable, and dual switches via a TRS cable.
Select "Mono Switch" or "Dual Switch" Mode on the corresponding "Pedal
1-6" page in System Settings and assign a
switching function with the soft knob labeled "Switch Tip". If "Dual Switch" is selected, another switching function can