Connecting Expression Pedals And External Switches; Remote Settings - Kemper PROFILER Main Manual

PROFILER Remote 202

Connecting Expression Pedals and External Switches

The PROFILER Remote offers four TRS-inputs named PEDAL 3-6 to connect expression pedals. If you should
happen to require more switches, you can connect mono and dual switches to these sockets, too. The technical
requirements are the same as when connecting expression pedals, or switches, directly to the PEDAL 1 and 2 inputs
on the rear side of the PROFILER. Their functions can be assigned in the System Settings of the PROFILER on
"Pedal 3-6
pages (Remote)". More information and configuration examples can be found in the dedicated chapter
about expression pedals and foot switches.

Remote Settings

You can find a dedicated LCD CONTRAST knob on the rear side of the PROFILER Remote. All other LCD and LED
settings are edited on page "Remote Settings" within the System Settings of the PROFILER. The physical LCD
contrast knob overwrites the corresponding setting in the System Settings during startup.
The display reflects the most relevant information depending on the mode of operation. In Performance Mode you
can chose between two display layouts on the "Remote Settings" page in Settings. On the "Date and Time"
System
page, you can find an option to display the current time on the Remote.
Looper Volume is explained in the paragraph Looper.
Incidentally, all these settings are also included in PROFILER backups.