Auxiliary Input - Kemper PROFILER Main Manual

Output Section 79
recording. By selecting the option "Space>HeadphOnly", you can select whether it is applied to the
HEADPHONE
output only, or to the MAIN OUTPUTS as well.
You can also apply the Space effect to individual Rigs, rather than activating it globally in the Output Section. In this
case, simply use the TYPE knob to select it in either the X or MOD effect.
The Space effect is also very useful for improving the sound of in-ear monitors on stage. Unfortunately, in most
situations, both stage-monitoring and FOH are derived from the MAIN OUTPUTS - as a result, the effect will appear
on the main PA as well. As long as you use Space at a suitably low Intensity setting, it will not be noticeable on the
PA sound, but will still create a reasonable effect on your in-ear monitors. Needless to say, the monitor signal must
be supplied in stereo for Space to have the desired effect.

Auxiliary Input

The Auxiliary Input function allows you to feed a stereo signal, such as an mp3-player, into your PROFILER to play
along with it. In the Output Section, the Auxiliary Input function is equipped with three mix controls: one to feed the
aux signal to the MAIN OUTPUTS as well as S/PDIF OUTPUT, and two others to feed it to the MONITOR OUTPUT
and HEADPHONE output. This allows you, for instance, to add an additional monitor signal to your HEADPHONE
output, while the MAIN OUTPUTS stay unaffected. With the activation of "Monitor Stereo" MONITOR OUTPUT and
DIRECT OUTPUT get paired as one logical stereo monitor output. The Aux In signal will also appear on both and its
mix gets controlled via "Aux In >Monitor". The auxiliary signal will not be affected by any internal effects.
You will need to purchase a special cable which provides the stereo signal via two separate TS jacks. Plug the left
jack into the RETURN and the right jack into the ALTERNATIVE INPUT. Use the "Aux In >..." soft knobs to adjust
the level.
While you have an Effect Loop active in your Rig, or you are in PROFILER Mode, the Auxiliary Input cannot be used,
since the physical inputs are needed for a different purpose.
✓
To prevent unwanted hum and noise, please remember to turn down the Auxiliary Input volume when you are not
using it.