Transmitting User Interface To Midi Global Channel; Nrpn - Kemper PROFILER Main Manual

MIDI 214

Transmitting User Interface to MIDI Global Channel

If "UI to MIDI" is selected in
System Settings, nearly all parameter changes within the PROFILER user interface, and
the connected PROFILER Remote, will be forwarded through the MIDI OUT. You could, for instance, create a daisy
chain of PROFILER units, all following whichever commands you enter on the leading PROFILER, or connected
Remote, including any Rig or Slot changes.
This stream of MIDI commands will be sent on whichever channel has been selected to be the MIDI Global Channel.
If this is set to "Omni", MIDI channel 1 will be used for "UI to MIDI".
✓
If you intend to transmit other MIDI commands in Performance Mode, or if you want to transmit pedal controllers
simultaneously with "UI to MIDI", make sure that you either select different MIDI channels or different MIDI outputs to
avoid logical interferences. For example, if you're sending "UI to MIDI" via MIDI channel 1, select MIDI channel 2 and
3 for the two external devices.

NRPN

The PROFILER features more than 400 parameters, so you can't address them all with a standard MIDI control
message, which is limited to 128 parameters. However, the PROFILER also supports the NRPN (Non-Registered
Parameter Numbers) protocol, which allows the addressing of 16384 parameters, with a resolution of 16384 values
(14 bit).
For more detailed information regarding NRPN please consult MIDI Parameter Documentation, which is available
here: www.kemper-amps.com/downloads