Unassigning An Effect Module; Assigning A Second Effect Module; More Assignments - Kemper PROFILER Main Manual

PROFILER Remote 194
It also works the other way around: press and hold the module button on the PROFILER first, then step on the
desired Effect Button afterwards. The upper left LED of the Effect Button should now reflect the category color of the
effect you assigned e. g. orange for a wah effect. Now, you can activate or bypass the selected effect module by
stepping on the button on your PROFILER Remote. The lower left white LED indicates the on/off status of this effect
module.

Unassigning an Effect Module

To undo a current assignment, simply perform the same assignment procedure again. Gone!
The upper LEDs remain unlit if no effect is assigned.

Assigning a Second Effect Module

To add a second assignment to the same Effect Button, just repeat the process with another effect module. You will
notice the right LEDs by the Effect Button indicate both the effect category and on/off state of your second
assignment. Now, you can activate or bypass both effects by stepping on the button on your PROFILER Remote.

More Assignments

Even more effect modules can be assigned to the same Effect Button this way. However, the LEDs will only show
the first two assignments.