Trouble Shooting - Kemper PROFILER Main Manual

Trouble Shooting

This chapter is intended to help recognize certain error states which can be corrected by the user. Any error states
not covered here should be referred to KEMPER Support. Generally, please keep the PROFILER operating system
up-to-date and create backups on a regular base. The current operating system release and latest public beta are
always available on: www.kemper-amps.com/downloads

PROFILER doesn't power on
In case the PROFILER does not start, and the LEDs and display stay inactive, please check your electricity supply
and cabling. If these are intact, it is possible that the internal safety switch protecting the PROFILER against
overcurrent has been activated. In this case: pull the power cable, wait about two minutes, reconnect the cable, and
try to activate the PROFILER by turning the

PROFILER doesn't boot up completely
If the PROFILER has not been shut down properly with the
PROFILER isn't able to completely restart. In order to rebuild the internal database, please push and hold the
while you switch on with the chicken head knob. Hold the RIG button until the message "Initializing current
button
Rig" appears. Your data and settings are not impacted by this procedure.

Noisy outputs
If you should hear noise on any outputs, please check the GROUND LIFT buttons on the back panel. These may
only be used selectively, and must never be activated all at the same time. This is very important. Otherwise, you
might not only face a shielding issue, but also a serious health risk.
If it's just the
S/PDIF OUTPUT
contact with the PROFILER housing.
chicken head knob.
chicken head
that's producing noise, please ensure that the shielding of the RCA jack has no
Trouble Shooting 241
knob, the result could be that the
RIG