Legacy Delay; Reverb (Green) - Kemper PROFILER Main Manual

Effects 129

Legacy Delay

The Legacy Delay is based on the first delay algorithm made for the PROFILER. The main purpose is to maintain full
backward compatibility to rigs that have been created before the advent of PROFILER operating system 5.0. The
architecture of the Legacy Delay is like that of the Two Tap Delay. However, it features a bandpass filter with the
parameters Center Frequency and Bandwidth – this is in contrast to the other delays, that all utilize the more intuitive
low cut and high cut filter. If you are going for deeper edits of an already existing Legacy Delay, we recommend
changing the type to Two Tap Delay, or any other type, by using the TYPE knob. This way, you will benefit from their
improved parameter set.
If you are going to build a new delay from scratch, you should avoid the Legacy Delay for the same reasons.

Reverb (Green)

The reverb offers studio-quality algorithms and works closely with the delay effect. It comes with five different types
that allow you to determine the room size, ranging from Matchbox to Hall. These five reverb types are exclusively
available in the REV module.

Mix
Reverb "Mix" works exactly like the delay "Mix" parameter, and can be controlled with the dedicated knob in the
upper half of the panel.