Constant Latency - Kemper PROFILER Main Manual

✓
Also, make sure that "Aux In > Main" is completely turned down to prevent a feedback loop.
If you intend to just feed a mono signal in, activate "Aux >Mono". The signal will now be merged into both sides of all
stereo outputs.
✓
A tutorial video about the Auxiliary Input function can be found on:

Constant Latency

Normally, latency is optimized dynamically be as low as possible. However, in some specific configurations e. g.
playing through multiple PROFILER units simultaneously and mixing their output signals this dynamic optimization
could cause phasing issues. "Constant Latency" avoids such issues by keeping latency at a fixed, defined level.
www.kemper-amps.com/video
Output Section 81