Direct Control Knobs; Master Volume Knob - Kemper PROFILER Main Manual

For metal sounds, we recommend adding one of the special noise gate stomps in addition, which are explained in
the Noise Gate Stomps chapter.
With the chicken head knob
without influencing the resulting PROFILE.
✓
A tutorial video about the Input Noise Gate can be found on:

Direct Control Knobs (6)

Direct control knobs provide instant access to specific effects parameters. There are six on the PROFILER Head and
PowerHead, and four on the Rack and PowerRack models:
•
Modulation Rate and Modulation Intensity in the MOD module (Head/PowerHead only),
•
Delay Feedback and Delay Mix in the DLY module,
•
Reverb Time and Reverb Mix in the REV module.
The same parameters are also available in the respective effect menus.

MASTER VOLUME Knob (7)

Master Volume is the master of all output volumes and is always global. It is not stored as part of any Rig. Changing
the volume will not affect the color of the sound.
Volumes of all analog outputs including the
can be activated and deactivated with soft buttons in the
Master Volume maintains the relative volume settings of all outputs linked to it. For example, if MONITOR OUTPUT
Volume is set relatively low and Main Output Volume relatively high, and both are linked to Master Volume, you
set to PROFILER Mode, the Noise Gate will also work with the connected amplifier, but
HEADPHONE output
Output Section
Front Panel Controls 26
www.kemper-amps.com/video
are linked to Master Volume by default. These links
(e. g. "Headphone Link").