Setup Wireless Detectors (H5/A8) - Panasonic Firetracker FT128 Operation Manual

24.8

Setup Wireless Detectors (H5/A8)

This function can be used by commissioning / service engineer to set a Base station for
wireless units 4620 to one of the following modes:
Register: in order to register one or more wireless detectors 4611 to the Base station
Unregister: in order to unregister one or more wireless detectors 4611 from the Base
station
Install: in order to change the normal communication time from every 2
th
5 second, to be used during commissioning, etc.
Note: To set the Base station to any of the modes above, the Base station has to be in a
"Normal state" i.e. not set to any of the modes. For example, a Base station set to e.g.
"Register" mode has to be set back to "Normal state" before it can be set to any other
mode.
Action Text in display
"Access"
Scroll to menu H5.
"A" Calibration of supervised outputs
Scroll to menu A8
"A"
Write technical
address for the base
station, e.g. "001"
and mode, e.g. "0"
"A"
"A"
"Return"
For more information, refer to the manual for Wireless Units for Addressable FDCIEs.
Note: The procedure to set a Base station to the "Unregister" and "Install" mode
respectively (and back to the "Normal state") is the same as for the "Register" mode.
Service
Setup wireless detectors
Set base station mode 000 to mode 0
(0=Register, 1=Unregister, 2=Install)
Set base station mode 001 to mode 0
(0=Register, 1=Unregister, 2=Install)
Base station 001 set in register mode
Set base station mode 001 to mode 0
(0=Register, 1=Unregister, 2=Install)
Setup wireless detectors
ACCEPT? H5
ACCEPT? A1
ACCEPT? A8
ACCEPT? A8
117
Operation Manual
FT128 Rev 2.4
nd
minute to every
Comments
Log on to FT128 as
shown in page 35.
Press "A" to accept.
If more base stations shall
be set, continue like
above. If not, press
"Return" to menu A8.
Scroll or press "Return" to
menu H2.