Change Password (H10) - Panasonic Firetracker FT128 Operation Manual

29

Change Password (H10)

A password changed via menu H10 (+ H8/S5) will be valid until it is changed via menu
H10 again or it is erased via EBLWin (menu Tools / Reset user passwords).
If the valid password is unknown, EBLWin must be used to change the password.
Action
"Access"
Scroll to menu H10.
"A"
Enter the old and new
passwords and the new
password again.
Note: As long as you don't close the door you can enter the menu system again without
a password.
Note: After change of password, it is recommended to do a "Safe shutdown of the control
unit" (see menu H8/S7). This will save the SSW data (e.g. the new password) in a Flash
ROM (see page 82).
Use EBLWin to change the password(s) if they are forgotten.
Text in display
Change access code for daily duties
Password: _
New Password:
Password: ******
New Password: ****
Incorrect Password, NO change
Password is changed
Change Password
ACCEPT? H10
Verify:
Verify: ******
ACCEPT? H10
139
Operation Manual
FT128 Rev 2.4
Comments
Log on to FT128 as shown
in page 35.
The digits are replaced
(******) in the display.
Wrong password was
entered. Try again.
Correct password was
entered.
Scroll or press "Return" to
log off.