Table of Contents
Advertisement
6
User Data & Access Levels
6.1
User Data
FT128 software supports different levels for different users. To log on to FT128 (version ≥
2.0) a User name and a Password are required. Ten different User names with individual
Passwords can be used.
Ten different user names with individual passwords are available and can be defined via
EBLWin (menu "System") in the "User data" dialog box. One of three different levels /Types
can be selected for each user name. They can be used to log on to an FT128 (version ≥
2.0) and/or Web-server access.
Three user names and passwords are set as default as shown in this "User data" dialog
box:
Note 1: It is highly recommended to change the default user names and passwords and
to add a number of new user names and passwords. Also, the EBL and WEB columns
have to be filled in, depending on how the user names and passwords should be used.
Note 2: In a new FDCIE. (i.e. before downloading any Site Specific Data), only user "0"
is available. No password is required and you have access to all menus. After download
of SSD the downloaded user names and passwords will be valid.
6.1.1
User Name
Up to ten users, 0 to 9, may be programmed. By default, three users are available:
•
0 = Information only
•
1 = Building officer
•
2 = Service personnel
6.1.2
Password
Each user has a password for an access level e.g. "Information only", "Building officer" or
"Service personnel".
Change of Password
Normally the user names and passwords are downloaded / changed via EBLWin and SSD
download. A logged-on person (user name) can also change his/her password via menu
H10.
If the valid password(s) are unknown, EBLWin must be used to change the password(s).
CHANGE VIA MENU H10, See chapter 29
page 139 change password (H10).
34
Operation Manual
FT128 Rev 2.4
Advertisement
Table of Contents
