Table of Contents
Advertisement
21.10
Disable / Re-Enable Outputs for Routing Equipment
(H2/B10)
Disabled outputs are listed in menu H4/U1.
Outputs for routing equipment (Fire Brigade TX / fault TX) can be disabled and re-enabled
via this menu. Disabled output will stay disabled, until re-enabled again via this menu.
The function can be used during commissioning and testing of an installation, when only
local alarms are required but it can't be used during normal operation.
not be used to disable routing equipment.
Disabled output is indicated by LEDs "Disablements" (L8) and "Fault / Disablements Fire
Brigade TX" (L15).
Action
"Access"
Scroll to menu H2.
Disable or re-enable
Disable zone
"A"
Disable / re-enable outputs for
Scroll to menu B10
routing equipment
"A"
Routing equipment for FIRE: 1, FAULT:1
(1=enabled, 0=disabled)
All outputs to routing equipment for: FIRE is disabled /
e.g. "0"
FAULT is enabled
"A"
"A"
Routing equipment for FIRE:0, FAULT:1 (1=enabled,
0=disabled)
"Return"
Disable / re-enable outputs for routing equipment
"Return"
Disable or re-enable
Text in display
ACCEPT? H2
ACCEPT? B1
ACCEPT? B10
ACCEPT?
ACCEPT?
ACCEPT? B10
ACCEPT? H2
97
Operation Manual
FT128 Rev 2.4
This menu must
Comments
Log on to FT128 as shown in
page 35.
To move the cursor, press
"→". Edit and/or press "A" to
accept.
Scroll or press "Return" to
return to H2.
Scroll or press "Return".
Advertisement
Table of Contents
