Table of Contents
Advertisement
27.9
Activate Output (H8/S9)
Via this menu, a loop unit output, control unit output and expansion board output can be
activated.
Any output can be activated, which means the function can be tested. (Can also be done
via EBLWin.) This is including Addressable siren 4477, Addressable sounder base 3379,
wireless detector 4611, light indicator 4383, and all alarm devices 4480, 4481, 4482, 4487.
The selected output will be activated no matter if the control expression is true or not. The
selected output will be reset only if the control expression is false. If the control expression
is true when you reset the output via menu H8/S10, the output will remain activated until
the control expression is false again.
Action
Text in display
"Access"
Scroll to menu H8.
Maintenance
"A"
Acknowledge SERVICE signal
Scroll to menu S9.
Activate output
"A"
Activate output type: 0
0=Loop unit
Depending on if 0,
Activate output: 0, technical address 000
1, 2 or 3 is selected
one of the
Activate S0
alternatives will be
shown.
Activate R0
Activate output: 0, expansion board 0
"A"
Output 0 technical address 002
Depending on if 0,
forced active
1, 2 or 3 is selected
Output S0 forced active
one
of
the
alternatives will be
Output R0 forced active
shown.
Output 0 expansion board 0 forced active
"A"
Activate output type: 0
"Return"
0=Loop unit
"Return"
Activate output
"Return"
Maintenance
1=S 2=R0 3=EXPB
1=S 2=R0 3=EXPB
ACCEPT? S9
ACCEPT? H8
132
Operation Manual
FT128 Rev 2.4
Comments
Log on to FT128 as shown in
page 35.
ACCEPT? H8
ACCEPT? S1
ACCEPT? S9
Loop unit=3361 or 3364
S=S0-S1, R0=R0
ACCEPT?
EXPB= 4581 or 4583
Fill in the requested data
respectively and press "A".
ACCEPT?
ACCEPT?
ACCEPT?
ACCEPT?
If more outputs shall be
activated do as above, else
ACCEPT?
press "Return" to menu S9.
Scroll or press "Return" to
menu H8.
Scroll or press "Return".
Advertisement
Table of Contents
