Table of Contents
Advertisement
6.3.6
User Level 3A
When the door has been opened using 003 key (LED "Door open" is lit), the service /
maintenance personnel have access as per access level 1 and after log on as "Service
personnel" (level 3A
to the following menu:
Same menus as in access level 2B plus the following:
H5 Service
H8 Maintenance
H10 Change password (In this case for "Service personnel")
6.3.7
User Level 3B
Used by Service / maintenance / commissioning engineers when a PC (i.e. EBLWin) is to
be connected to FT128 for backup (upload), download of site specific data (SSD) and /or
download of software.
EBLWin require an EBLWin key (5094) to be plugged in the PC.
6.3.8
User Level 4
Used by manufacturer or by personnel authorised by the manufacturer for re-initialisation
(reset) of the alarm counter, change software configurations, on-line status checking, etc.
An EBLWin key (5094) is required to be plugged in the PC.
25
If the code for access level 3A has already been used to logon to access level 2B, a new logon to access level 3A is not
required.
25
), access to all levels in the menu, i.e. same as level 2B and also
A1 Calibration of supervised outputs
A2 Sensitive fault detection mode
A3 Service mode for COM-loop
A4 Display current consumption in unit
A5 Display current consumption on COM loop
A6 Display statistics for COM loop
A7 Activate address setting mode for DU
A8 Setup wireless detectors
A9 Setup wireless detectors
A10 Show information about site specific data
S1 Disconnect / Re-connect COM-loop
S2 Disconnect / Re-connect Zone Line Input
S3 Disconnect / Re-connect addressable zone interface input
S4 Acknowledge SERVICE signal
S5 Restore weekly average to default
S6 Test of alarm devices
S7 Safe shut down of control unit
S8 Activate zone / address in alarm mode
S9 Activate output
S10 Reset activated output
39
Operation Manual
FT128 Rev 2.4
Advertisement
Table of Contents
